
| Symptom | Most likely cause | Quick check on site |
|---|---|---|
| All functions slow together | Main piston pump losing volume | Cycle time test at operating temperature |
| Boom or bucket drifts down | Cylinder rod seal wear | Measure drift over ten minutes with load held |
| Temperature rises when idling | Fan pump or fan drive | Compare fan speed at idle and at high idle |
| Long crank, fuel starvation | Transfer or lift pump | Priming and supply pressure check |
| Play at link joints | Pin assemblies | Visual gap and movement under load |
The 254-5146 hydraulic piston pump is the part most customers ask for by name. Before we ship, we confirm port orientation and mounting against the serial number, because 950H and 962H builds differ across production years. If the pump body itself is sound, a repair path is often available and cheaper than a complete unit.
Boom drift is almost always a seal problem, not a pump problem. We stock the 381-2331 hydraulic cylinder seal kit for the 950H and 962H and usually ship one kit per cylinder being rebuilt. Seals are cheapest when bought with the pump, not after discovering the drift continues.
A machine that runs all day in a European quarry in summer will show cooling problems well before it shows power problems. The 191-2942 fan pump is a common replacement on 962H machines, and for machines that also show fuel starvation we supply the 162-9612 fuel transfer pump used across the older G-series loaders.
Linkage play is often mistaken for hydraulic slack. The 5V-1511 pin assembly for 962H and 962K is a frequent small order that restores much of the precision people assume needs a pump rebuild.
We consolidate pump, seal and pin orders into one crate for European customers so that everything arrives for the same planned workshop slot. Each carton is marked with the part number, per-piece weights are listed for customs, and a loading video accompanies every shipment.
It is specified across both models, but port orientation and mounting differ between production years, so we check it against your machine serial number before dispatch.
Almost always cylinder seals, not the pump. Measure drift over ten minutes with the load held, then rebuild with a seal kit such as 381-2331.
Yes. Pump, seals and pins are consolidated into one crate so everything lands ahead of the same slot, with a loading video and a per-piece weight list.
Machine serial number, the old part number from the nameplate, and one photo of the installation position. We answer the same working day with stock confirmation and real photos.
Send the serial number and the old part number — we confirm stock and send photos the same day.

WhatsApp +86 139 2519 9399 · Scan and send your part number, or open the chat directly